Remove/install rear door liner

AR72.12-P-1011MFA

Remove/install rear door liner

14.08.2019

Model

118, 177, 247

Shown on model 177.0

1

Door trim

4

Retaining clips

2

Bolts

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Open side window of left and/or right rear door.

2

Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).

3

Open left/right rear door completely.

4

Remove cover above door trim.

Model 247.0

 Installation: Replace damaged retaining clips.

 Dismantling tool

*000589956300

5

Remove screw/bolts (2) .

6

Unclip door trim (1) all around and lift up until the electrical connectors are accessible.


Do not crush or kink or subject lines to tension.
This will result in damage to the lines which may impair their functional capability.

 Long wedge

*115589035900

7

Release and disconnect electrical connectors of door trim (1).

 The number of electrical connectors varies according to vehicle equipment.

8

Unhook wire from inside door opener.

9

Remove door trim (1) at rear door.

 First lift up front of door trim (1) then remove to the rear.

 Installation: Replace damaged retaining clips (4).

10

Install in the reverse order.