Remove/install rear door

AR72.12-P-0600TX

Remove/install rear door

19.7.10

6.6.06

"Disconnect/connect battery ground line" removed

 

Remove/install

 Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof.

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

1

Remove ashtray in rear door

AR72.12-P-1041TX

2

Disconnect electrical connectors (2).

3.1

Disconnect electrical connector (3)

On vehicles with code (889) Keyless go

4

Remove cover (4) on bolts (5) from door holder (6)

5

Remove bolts (5)



*BA72.12-P-1001-01J

6

Unclip protective hose (7) from rear door (1) with mounting wedge and pull electrical lines now accessible out of rear door (1).



*110589035900

7

Press caps (8) off of screws (9) with suitable screwdriver

8

Remove bolts (9)



*BA72.12-P-1005-01J

9

Remove rear door (1) from door hinges upward and lay down on suitable subsurface

 Carefully remove rear door (1) from door hinges with aid of helper and lay down on suitable subsurface, otherwise the paint on the rear door (1) can be damaged.

10

Install in the reverse order

11

Check gap dimensions at rear door (1)

 See:

Gap dimensions on hoods, doors and lids

AR60.00-P-0700-01Y

*BE60.00-P-1002-01O



*129589032100

 If necessary, adjust rear door (1)
Refer to:

Adjust rear door

AR72.12-P-0650TX

Number

Designation

Model
219

BE60.00-P-1002-01O

Gap dimension

Fender to A-pillar

Dim. "D"

mm

3.0 (1)

Front door to fender

Dim. "E"

mm

4.0 (-0.5/+1)

Front door to rear door

Dim. "F"

mm

5.0 (-1/+0.5)

B-pillar cover to front window

Dim. "G"

mm

10 (1)

B-pillar cover to rear window

Dim. "H"

mm

10 (1)

Rear door to side section, bottom

Dim. "I"

mm

3.5 (-0.5/+1)

See picture

AR60.00-P-0700-01Y

Number

Designation

Model
219.3

BA72.12-P-1001-01J

Bolt, door holder to B-pillar

Nm

14

BA72.12-P-1005-01J

Bolt on door hinge half connection

Nm

22