P72.10-3345-09
1 Door lock
2 Door handle guide
3 Door handle
4 Seal
9 Bolts
10 Electrical connector
11 Cable tie
12 Electrical connectors
5 Bolt
6 Bearing bracket
7 Bolts
8 Cover
P72.10-3346-09
1 Door lock
2 Door handle guide
3 Door handle
6 Bearing bracket
16 Release rod
17 Adjustment screw
A Clearance
13 Cover
14 Control cable
15 Control cable
| Removing | ||
1 | Remove front door lining | ||
2 | Remove door handle (3) from left and right front door. | ||
3 | Remove seals (4) and loosen bolts (5). | ||
4 | Loosen rear window guide rail on power window and lay down in front door. | It is not necessary to remove left front power window motor or right front power window motor from power window. | |
5 | Push bearing bracket (6) toward front and unhook from front door | ||
6 | Unscrew bolts (7) and unclip cover (8) from door lock (1). | ||
7 | Remove bolts (9) | ||
8 | Remove door lock (1). | ||
9 | Disconnect electrical connector (10) and loosen from cover (8). | ||
10 | Separate cable tie (11) | ||
11 | Remove door lock (1) from front door and disconnect electrical connectors (12). | ||
12.1 | Unclip bearing bracket (6) from door lock (1) | When replacing door lock (1) | |
13 | Remove cover (13) | ||
14.1 | Unhook Bowden cables (14, 15) and release rod (16) from door lock (1). | When replacing door lock (1) | |
| Install | ||
15.1 | Hook release rod (16) into upper hole of retaining lever on door lock (1). | When replacing door lock (1) | |
16.1 | Hook Bowden cables (14, 15) into door lock (1) | When replacing door lock (1) | |
17.1 | Install bearing bracket (6) on door lock (1) | When replacing door lock (1) | |
18.1 | Install door handle (3) on bearing bracket (6) | When replacing door lock (1) | |
19.1 | Install door handle guide (2) in bearing bracket (6). | When replacing door lock (1) | |
20.1 | Adjust clearance (A) on adjusting screw (17) | When replacing door lock (1) | |
Lift anti-twist lock on bearing bracket (6) to turn adjustment screw (17). | |||
21 | Install new cover (13) | ||
22.1 | Remove door handle (3) from bearing bracket (6) | When replacing door lock (1) | |
23.1 | Remove door handle guide (2) from bearing bracket (6). | When replacing door lock (1) | |
24 | Connect electrical connectors (12) with door lock (1), position door lock (1) in front door and fasten with bolts (9). | ||
25 | Route electric wiring harness on cover (8), connect electrical connector (10) and clip cover (8) into door lock (1). | ||
26 | Screw in screws (7) | ||
27 | Tighten bolts (9) | | |
28 | Hook bearing bracket (6) into front door and tighten bolts (5). | ||
29 | Position seals (4). | ||
30 | Install door handle (3) on front door | ||
31 | Position rear window guide rail on power window in center in bottom mount and fasten. | ||
32 | Install door lining in front door |
Test values for front door
Front door