ar7210p2400mfa

Remove/install outside door handle on front door

Typ ar · temat 72.10 · wersja 0102 · 2018-12-13

Dotyczy: Model 118, 177, 247

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 72 Drzwi › 72.10 Drzwi przednie — Seria 118 · Seria 177 · Seria 247

EinPAS 29 System uprawniający do jazdy/zabezpieczający › 29.16 Blokowanie/ odblokowanie › 29.16.32 Zamek/ klamka — Seria 118 · Seria 177 · Seria 247

AR72.10-P-2400MFA

Remove/install outside door handle on front door

12.12.2018

Model

118, 177, 247

Remove/install outside door handle on front door

P72.10-4984-09

1

Plug

4

Lock cylinder

2

Screw

6

Fuse

3

Door handle

Remove/install outside door handle on front door

5

Cover

P72.10-4982-06

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Notes on safety-relevant components

AH00.00-Z-0019-01A

Remove

1

Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).

Model 118, 177, 247
with code 889 (KEYLESS-GO)
with code 896 (Vehicle access and drive authorization via mobile phone)

2

Remove stop plug(1).

3

Loosen screw (2).

Do not remove screw (2) completely.

4.1

Pull door handle (3) up to end stop and remove lock cylinder (4).

When removing door handle (3) from the driver's door.

When removing lock cylinder (4), the door handle (3) should must arrest in the pulled position.

If the door handle (3) does not engage,

re-insert lock cylinder (4) with pulled door handle (3) and release door handle (3). Then repeat operation step.

4.2

Pull door handle (3) up to end stop and remove cover (5).

When removing door handle (3) from the front passenger door.

When removing cover (5), the door handle (3) should must arrest in the pulled position.

If the door handle (3) does not engage,

re-insert cover (5) with pulled door handle (3) and release door handle (3). Then repeat operation step.

5

Guide door handle (3) out of the retainer (6) at the rear and pull out at the front.

Install

6

Insert door handle (3) into retainer (6) at the rear and install at the front.

Ensure correct seating of the door handle (3) in the retainer (6).

7.1

Install lock cylinder (4).

When installing the door handle (3) in the driver's door.

The catch of the door handle (3) is released when inserting the cover (5).

7.2

Install cover (5).

When installing the door handle (3) in the front passenger door.

The catch of the door handle (3) is released when inserting the cover (5).

8

Tighten bolts (2) fully.

9

Install stop plug (1).

Powiązane dokumenty