P72.10-4820-09
1 | Sealing rail | 3 | Door handle | 5 | Cover (only on passenger door) | ||
2 | Screw | 4 | Lock cylinder (only on driver) |
P72.10-4537-07
3 | Door handle | 6 | Fuse |
| Remove | ||
1 | Detach sealing rail (1) in area of screw (2). | ||
2 | Loosen screw (2). | The bolt (2) cannot be unscrewed completely. | |
3.1 | Pull door handle (3) to end stop and remove lock cylinder (4). | Driver's door | |
When removing lock cylinder (4), the door handle (3) should must arrest in the pulled position. | |||
If door handle (3) does not arrest, | |||
| |||
insert lock cylinder (4) with pulled door handle (3) and release door handle (3). Then repeat operation step. | |||
3.2 | Pull door handle (3) to end stop and remove cover (5). | Passenger door | |
When removing cover (5), the door handle (3) should must arrest in the pulled position. | |||
If door handle (3) does not arrest, | |||
| |||
insert cover (5) with pulled door handle (3) and release door handle (3). Then repeat operation step. | |||
4 | Guide door handle (3) out of retainer (6) at rear and pull out at front. | ||
| Install | ||
5 | Install door handle (3) in retainer (6) at rear and insert at front. | Ensure that door handle (3) arrests in retainer (6). | |
6.1 | Insert lock cylinder (4). | Driver's door | |
The catch of the door handle (3) is released when inserting the lock cylinder (4). | |||
6.2 | Insert cover (5). | Passenger door | |
The catch of the door handle (3) is released when inserting the cover (5). | |||
7 | Tighten bolts (2) fully. | ||
8 | Secure sealing rail (1). |