Remove/install front door lining

AR72.10-P-1000RG

Remove/install front door lining

16.07.2020

Model

190

Modification notes

09.07.2020

Document revised completely.

Shown on model 190.3 other than code M032 (black series version)

1

Door lining

5

Cover

9

Retaining clips

2

Front door

6

Bolts

10

In-door speaker electrical connector

3

Adhesive tape

7

Cover

11

Inside door handle electrical connector

4

Long wedge

8

Screw

12

Inside door opener wire

Shown on model 190.4

13

Airbag cover

14

Nut

Shown on model 190.3 with code M032 (black series version)

6

Bolts

8

Screw

15

Covers

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Switch on ignition and lower corresponding front door side window.

2

Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).

3

Affix suitable tape (3) to armrest.

Model 190
except code M032 (Black Series version)

4.1

Remove panel (5).

Model 190
except code M032 (Black Series version)


Unclip cover (5) from front door (2), as shown, starting at rear and working forward.
Otherwise cover (5) can be damaged.

 Dismantling tool

*000589956300

4.2

Remove covers (15).

Model 190
with code M032 (Black Series version)

 Dismantling tool

*000589956300

5

Remove screws (6).

6

Remove cover (7).

 Dismantling tool

*000589956300

7

Remove screw (8).

8

Remove airbag cover (13) and remove nut (14).

Model 190.4

 Nut, headbag to driver door/front passenger door

*BA91.60-P-1001-01N

 Dismantling tool

*000589956300

9

Unclip door lining (1) at retaining clips (9) from front door (2).


Do not crush or kink or subject lines to tension.
This will result in damage to the lines which may impair their functional capability.


Position long wedge (4) in each case at retaining clips (9).
Otherwise the retaining tabs on the retaining clip (9) of the door lining (1) can tear off.

 Long wedge

*115589035900

10

Unclip door lining (1) from front door (2) until in-door speaker electrical connector (10), inside door opener electrical connector (11) and inside door opener wire (12) can be accessed.


Do not crush or kink or subject lines to tension.
This will result in damage to the lines which may impair their functional capability.

 Long wedge

*115589035900

11

Release and disconnect in-door speaker electrical connector (10) and inside door opener electrical connector (11).

12

Detach wire (12) at door handle.

13

Remove door lining (1).

 Long wedge

*115589035900



Check

14

Check retaining clips (9) of door lining (1) for damage.

If retaining clips (9) are damaged:



Replace corresponding retaining clips (9).

15

Install in the reverse order.

 Airbag

Number

Designation

Model 190

BA91.60-P-1001-01N

Nut, headbag to driver door/front passenger door

Nm

8