Additional work when replacing side paneling

AR68.30-S-4780-01EE

Additional work when replacing side paneling

Model

447.8

with code ZK7 (Equipment line MARCO POLO)

1

Cut out soundproofing (2) in area of cutout for seat bench cushion (3).

2

Mark cutout for seat bench cushion (3) on side paneling (1).

 The top edge of the cutout for the seat bench cushion (3) is located at the same height as the bottom edge of the cutout (arrow A) of the side paneling (1).

 The reference point for the dimension (b) on the side paneling (1) is the rear edge (arrow B) of the side paneling (1).
To determine the dimension (d), the measuring tape should make complete contact with the contour of the side paneling (1).
Dimension (a): 260 mm.
Dimension (b): 695 mm.
Dimension (c): 110 mm.
Dimension (d): 65 mm.

3

Make cutout for seat bench cushion (3) with suitable tool.

4

Mark hole for opening of bed extension mount (4) on side wall paneling (1).

 The reference point for the dimension (f) on the side paneling (1) is the rear edge (arrow B) of the side paneling (1).
Dimension (e): 267 mm.
Dimension (f): 635 mm.

5

Make for bed extension mount (4) using suitable tool.

 The diameter is 26 mm.

6

Cut out soundproofing (2) in area of cutout for trunk lamp (5) as shown.

7

Mark cutout for trunk lamp (5) on side paneling (1).

 To determine the dimension (j), the measuring tape should make complete contact with the contour of the side paneling (1).
Dimension (g): 50 mm.
Dimension (h): 27 mm.
Dimension (i): 30 mm.
Dimension (j): 80 mm.

8

Make cutout for trunk lamp (5) using suitable tool.