S68.20-2502-09
1 Rear door sill molding
2 Sliding door sill molding
3 Cover below B-pillar
6 Protective cap
7 Air outlet cover
4 Retaining eye mounting screw
5 Retaining eye
| Removal, installation | ||
1 | Remove seats in passenger compartment | See Owner's Manual | |
2 | Remove inner paneling on side of load compartment | ||
3 | Remove side paneling in rear | ||
4 | Remove paneling on B-pillar | ||
5 | Remove door sill molding (1) | ||
6 | Remove door sill molding (2) in area of sliding door | ||
7 | Remove cover (3) below B-pillar | ||
8 | Unscrew mounting screws (4) for retaining eyes (5) in floor covering | Remove protective cap (6) Installation: Before installing floor covering ensure that spacer plates are properly positioned, fasten with adhesive tape, if necessary | |
9 | Remove air outlet covers (7) in footwell | ||
10 | Remove floor covering | ||
11 | Reinstall in opposite order |