P68.20-2039-09
1 Manual router
2 Handle and tensioning knob
3 Depth limitation pin
4 Fixing screw
5 Turn table depth stop
6 HSS single-lip cutter 5 90 mm
7 Clamping pliers nut
8 Copy guide sleeve 12 mm
9 Spacer frame FD 3/129
10 Locating mount FO 2/129
11 Copy template K1.1/124
12 Tensioning device
| Removal | ||
1 | Remove wooden cover from upper switch level on center console | ||
2 | Remove stowage compartment from wooden cover | ||
Processing | |||
| Cut wooden cover of upper switch level from rear | ||
3 | Mask painted cover surface in area of desired switch opening with paper adhesive strip. | ||
4 | Insert locating mount (FO 2/129) and spacer frame (FD 3/129) into cover | | |
5 | Insert cover together with locating mount (FO 2/129) and spacer frame (FD 3/129) into locating and clamping device and clamp tight | Do not tighten handwheel too tight so that cover cannot distort. | |
6 | Insert copy template K1.1/124 (11) into mounting pins | | |
7 | Cut switch opening with manual router | Switch opening should be cut in three cutting steps. | |
| |||
8 | Unclamp wooden cover and remove paper adhesive tape | ||
9 | Blacken visible cutting areas on cover with black felt pen | ||
| Installation | ||
13 | Install cover |
Commercially available tools