P68.20-2748-09
1 Stowage compartment
2 Accessory parts
3 Vertical strut
4 Screws
9 Electrical connector
10 Electrical connector
5 Center console
6 Screws
7 Screw
8 Electrical connector
P68.20-2749-01
11 Electrical connector
| Remove/Install | ||
1.1 | Remove radio | On vehicles with code (C01, CO2, C12, C16, C21, C25 or C26). | |
2 | Pull stowage compartment (1) out to stop and remove. | Press arrests (arrows) to inside and pull stowage compartment (1) over arresting points. | |
3 | Remove pushbuttons from actuating lever on heater control unit. | Carefully remove pushbutton to prevent damage to the actuating levers of the heater control unit. Installation: Observe installation position of pushbuttons in relation to actuating levers. | |
4 | Remove cockpit switch group | ||
5 | Remove end caps (arrows), unscrew screws underneath and remove accessory parts (2) from vertical strut (3). | ||
6 | Unscrew screws (4) from center console (5). | ||
7 | Unscrew screws (6) from upper center console (5). | ||
8 | Unscrew screws (7) from center console (5). | ||
9 | Lift center console (5) until electrical connectors (8, 9) are accessible. | ||
10 | Separate electrical connectors (8, 9) | ||
11.1 | Separate electrical connector (10) | On vehicles with code (V07) fog lamp (FFO). | |
12.1 | Disconnect electrical connector (11). | On vehicles with code (L16) Japan. | |
13 | Remove center console (5). | When replacing center console (5). | |
Transfer 12 volt socket. | |||
Transfer interior light switch. | |||
Transfer fog lamp switch. On vehicles with code (V07) fog lamp (FFO). | |||
14 | Install in the reverse order | ||
15 | Set cockpit clock. | See Owner's Manual |