Adjusting rear side windows

AR67.30-P-4200R

Adjusting rear side windows

13.9.11

Adjust

 Danger!

Risk of injury caused by moving parts that can pinch, crush or, in extreme cases, even sever extremities

No parts of the body or limbs should be within the operating range of the mechanism when moving components.

AS00.00-Z-0009-01A

1

Close Vario roof

2

Check adjustment of front crank window (8) on driver door

 If necessary, correct adjustment

AR72.10-P-1950R

3

Remove rear passenger compartment side trim panel

AR68.30-P-4780R

4

Remove paneling from upper center pillar

AR68.30-P-1077R

5

Close Vario roof fully with the soft top switch

6

Screw height stops up (2)

 Do not screw up height stops (2) too high, otherwise caps (3) could fall down.

7

Loosen bolts (4) on rear side window (1) on power window (6)

8

Adjust insertion depth (A) by moving rear side window (1) in window mount (5) on power window (6)

 Check dimension for insertion depth (A) over entire length of rear side window (1).

Mark position of sealing lip bottom edge of seal (7) with wax pin or similar over entire length.

*BE67.30-P-1004-01A

9

Tighten bolts (4) on rear side window (1) on power window (6)



*BA67.30-P-1001-01B

10

Close front crank window (8) and rear side window (1)

11

Loosen counternut (9)

12

Adjust offset (C) between front crank window (8) and rear side window (1) (arrows C) by turning adjustment screws (10)

 Always adjust window inclination with both adjustment screws (10)

The offset (C) is adjusted by changing the window inclination

Windows should be positioned parallel to one another

*BE67.30-P-1005-01A

13

Tighten power window (6) with counternut (9)



*BA67.39-P-1002-01A

14

Install mounting wedge (11) between locking eye (12) and door contact switch and close window completely



*110589035900

15

Screw height stops (2) in to stop

16

Remove assembly wedge (11)



*110589035900

17

Adjust window overlap in relation to outer sealing rail (13)

 Adjust by moving depth stop (14)

The depth stop (14) is adjusted with rear side window (1) closed.

The trim strip (15) of the bar seal (16) for the rear side window (1) should be flush with the outer sealing rail (13) (arrow B). The left and right side windows should be positioned at the same height in the opened position.

18

Close Vario roof fully with the soft top switch

19

Install paneling at upper center pillar

AR68.30-P-1077R

20

Install side paneling in rear passenger compartment

AR68.30-P-4780R

21

Check rear side window (1) for proper function

Number

Designation

Model 230

BE67.30-P-1004-01A

Insertion depth of rear side window in seals on Vario roof

Dimension "A"

mm

5 to 7

See picture

-

BE67.30-P-1005-01A

Offset between front crank window and rear side window

-

mm

0 to 2

See picture

-

Number

Designation

Model
230

BA67.30-P-1001-01B

Screw, rear side window to window lifting mechanism

Nm

9

Number

Designation

Model
230

BA67.39-P-1002-01A

Locknut for electric power window mount in center pillar

Nm

9