ar6730p010004fr

Adjust height of front side window

Typ ar · temat 67.30 · wersja 0101 · 2018-08-06

Dotyczy: Model 257, 290

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 67 Szyby i okna › 67.30 Szyby boczne — Seria 257 · Seria 290

EinPAS 36 Widoczność › 36.15 Szyba szklana/ okno › 36.15.41 Okno boczne — Seria 257 · Seria 290

AR67.30-P-0100-04FR

Adjust height of front side window

Model

257, 290

Side window(s)

Number

Designation

Model 257.3

Model 290

BE67.30-P-1001-03E

Insertion depth of front door side window in roof edge

Dimension "a"

mm

5 (1)

5 (1)

Adjust height of front side window

129 589 03 21 00

Feeler gauge

Adjust height of front side window

P67.30-2435-09

Adjust immersion depth (a) of the front side window (1) in the roof edge seal (20), shown on model 257

1

Close front door.

2

Insert screwdriver (21) between the door paneling (22) and the front side window (1) in the setting screw (arrow C) of the front mount (24) of the window lifter (23).

3

Adjust immersion depth (a) of the front side window (1) in the roof frame seal (20) by turning the setting screw (arrow C).  

Turning the setting screw (arrow C) clockwise lowers the front side window (1) at the front.
Turning the setting screw (arrow C) counterclockwise raises the front side window (1) at the front.

4

Insert a screwdriver (21) between the door paneling (22) and the front side window (1) in the setting screw (arrow D) of the rear mount (25) of the window lifter (23).

5

Adjust the immersion depth (a) of the front side window (1) in the roof frame seal (20) by turning the setting screw (arrow D) .

Turning the setting screw (arrow D) clockwise lowers the front side window (1) at the back.
Turning the setting screw (arrow D) counterclockwise raises the front side window (1) at the back.

Taper of dimension (b) can change due to adjustment of window guide depth (a) of front side window (1) in roof frame seal (20).

6

Check taper of dimension (b) with feeler gauge.

A taper of dimension (b) of max. 1 mm is permitted from top to bottom.
In the event of a taper greater than 1 mm, this must be adjusted within the tolerances by changing the immersion depth (a) of the front side window (1) in the roof frame seal (20).

7

Open front door.

8

Switch on ignition.

9

To check the settling properties of the front side window (1), open and close it several times.

10

Switch off ignition and store transmitter key outside of transmitter range (at least 2 m).

11

Close front door.

12

Check immersion depth (a) of the front side window (1) in the roof frame seal (20) again.

If there is a problem,

repeat adjustment procedure.