P65.20-2348-01
1 Cartridge tip
A Dimension
B Dimension
P65.20-2347-06
2 Rear trim strip
| Remove | ||
1 | Remove roof shell | See owner's manual. | |
Installation: Pay attention to leaktightness. | |||
2 | Remove side struts | See owner's manual. | |
Installation: Pay attention to leaktightness. | |||
3 | Pull off rear trim strip (2) | For this purpose, lift rear trim strip (2) in area of strip ends | |
| Clean | ||
4 | Remove glue residues | Do no use sharp-edged aids to prevent damage to paint | |
5 | Clean paint surface | ||
| Install | ||
6 | Apply primer to inside of rear trim strip (2) and surface of trim seam | Use suitable brush.Fasten rear trim strip (2). | |
Observe drying time for primer | |||
The sealing surfaces must be free of dust and grease. | |||
7 | Cut cartridge tip (1) | Dimension (A) is 3 mm, dimension (B) is 2 mm. | |
8 | Apply glue bead. | Dimension A: Uniformly apply glue from edge to edge on trim seam or inside of rear trim strip (2) | |
Since the trim seam has various thicknesses, adapt thickness of glue bead in individual cases.The glue bead should have a triangular cross section | |||
The sealing surfaces must be free of dust and grease. | |||
9 | Insert rear trim strip (2) | Figure B: On model 452.4 the rear trim strip (2) is wedged in the roll bar spoiler | |
10 | Press on rear trim strip (2) and fasten | Figure C: Use suitable adhesive tape to fasten rear trim strip (2). | |
Observe drying time for glue; the rear trim strip (2) should be fastened during the drying time. | |||
Drying time for 1-component glue: 60 - 90 minutes. | |||
Drying time for 2-component glue: 15 - 20 minutes. | |||
11 | Remove fastener | Maintain drying time | |
12 | Remove extending glue residues | Do not damage affected components.Use a suitable tool. | |
13 | Clean adjacent paint surfaces | ||
14 | Clean adjacent plastic surfaces | ||
15 | Install side struts | See owner's manual. | |
Ensure leaktightness. | |||
16 | Install roof shell | See owner's manual. | |
Ensure leaktightness. |