P65.10-3240-08
1 Position metal needle template (2) on Y-markings (arrows) at rear on side of roof paneling (1) and scribe cut (area A).
2 Position metal needle template (2) according to dimension (b) at front on side roof paneling (1) and scribe cut (area B).
Transfer dimension (b) from new part.
3 Cut along broken lines using body saw (area A and B).
Observe sheet metal below.
P65.10-3227-09
4 Expose spot welds on side roof paneling (1) and cut out (areas C, D, E and F).
P65.10-3228-09
5 Heat side roof paneling (1) in cross-hatched areas with hot air gun and remove.
Cross-hatched areas are foamed and bonded. Damaged foam parts must be removed and replaced.
P65.10-3229-06
For all other operation steps, observe information on pretreatment of bonding surfaces.
6 Grind mating surfaces down to bare metal in cross-hatched areas using round wire brush on both sides (areas G and H).
7 Grind all other mating surfaces in cross-hatched areas on one side using round wire brush.
8 Remove grinding and drill shavings using wet/dry vacuum cleaner.