Model | 907.2 |
Model | 907.6 |
except code D03 (Roof and rear-end doors, high version) | |
except code D05 (Super-high roof) | |
except code D06 (Super-high roof painted in vehicle colour) | |
except code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.6 |
except code D03 (Roof and rear-end doors, high version) | |
except code D05 (Super-high roof) | |
except code D06 (Super-high roof painted in vehicle colour) | |
except code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 907.7 |
except code D03 (Roof and rear-end doors, high version) | |
except code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.7 |
except code D03 (Roof and rear-end doors, high version) | |
except code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 910.6 |
except code D03 (Roof and rear-end doors, high version) | |
except code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 910.6 |
except code D03 (Roof and rear-end doors, high version) | |
except code T19 (Sliding door left) | |
Left side of vehicle |
Additional information can be found in the superordinate service document.
The safety information in the superordinate service document must be observed.
The following operation steps are shown on the left component part in model 907.633 and must be similarly performed on the right side of vehicle in the event of damage.
1 | Punch holes in side roof paneling (1) with Ø 6 mm (areas A and B). |
Commercially available devices/tools |
2 | Grind side roof paneling (1) down to bare metal in cross-hatched areas and around holes (areas A and B). |
Commercially available devices/tools |
3 | Remove shavings. |
Commercially available devices/tools |
D65.10-1422-11