Model | 907.6/7, 910.6 |
with code D03 (Roof and rear-end doors, high version) | |
except code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.6/7, 910.6 |
with code D03 (Roof and rear-end doors, high version) | |
except code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 907.6 |
with code D05 (Super-high roof) | |
except code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.6 |
with code D05 (Super-high roof) | |
except code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 907.6 |
with code D06 (Super-high roof painted in vehicle colour) | |
except code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.6 |
with code D06 (Super-high roof painted in vehicle colour) | |
except code T19 (Sliding door left) | |
Left side of vehicle |
Additional information can be found in the superordinate service document.
Safety information in the superordinate KD document must be observed.
The next steps are shown on model 907.733 with code D03 (roof and rear-end doors, high version) except code T19 (left sliding door) on the left component part and must be carried out in the same way for vehicles except code T16 (right sliding door) on the right side of the vehicle in the event of damage.
D65.10-1405-09
a | Dimension (8 mm) |
1 | Mark separating point on side roof paneling (1) (area A). |
Observe dimension (A). |
2 | Disconnect separating point from side roof paneling (1) (area A). |
Commercially available devices/tools |
3 | Dispose of the leftover piece that has been separated off. |
4 | Punch holes in side roof paneling (1) with a diameter of 6 mm (area B). |
Commercially available devices/tools |
5 | Grind side roof paneling (1) down to bare metal in cross-hatched area and around holes (area B). |
Commercially available devices/tools |
6 | Remove shavings. |
Commercially available devices/tools |
7 | Punch holes in side roof paneling (1) with a diameter of 6 mm (area C). |
Commercially available devices/tools |
8 | Grind side roof paneling (1) down to bare metal in cross-hatched areas and around holes (area C). |
Commercially available devices/tools |
9 | Remove shavings. |
Commercially available devices/tools |
D65.10-1406-06