Model | 907.6/7 |
with code D03 (Roof and rear-end doors, high version) | |
with code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.6/7 |
with code D03 (Roof and rear-end doors, high version) | |
with code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 907.6 |
with code D05 (Super-high roof) | |
with code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.6 |
with code D05 (Super-high roof) | |
with code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 907.6 |
with code D06 (Super-high roof painted in vehicle colour) | |
with code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.6 |
with code D06 (Super-high roof painted in vehicle colour) | |
with code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 910.6 |
with code D03 (Roof and rear-end doors, high version) | |
with code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 910.6 |
with code D03 (Roof and rear-end doors, high version) | |
with code T19 (Sliding door left) | |
Left side of vehicle |
Additional information can be found in the superordinate service document.
The safety information in the superordinate KD document must be observed.
The next steps are shown on model 907.733 with code D03 (roof and rear-end doors, high version) with code T16 (right sliding door) on the right component part and must be carried out in the same way for vehicles with code T19 (sliding door left) in the event of damage to the left side of the vehicle.
D65.10-1379-09
1 | Mark separating point on side roof paneling (1) (area A). |
Mark separating point along edge. |
2 | Disconnect separating point on side roof paneling (1) (area A). |
Commercially available devices/tools |
3 | Dispose of the leftover piece that has been separated off. |
4 | Punch holes in side roof paneling (1) with a diameter of 6 mm (areas B and C). |
Commercially available devices/tools |
5 | Grind mating surfaces on side roof paneling (1) in the cross-hatched area and around the holes (areas B and C) down to bare metal. |
Commercially available devices/tools |
6 | Remove shavings. |
Commercially available devices/tools |
D65.10-1380-09
7 | Punch holes on side roof paneling (1) with a diameter of 6 mm (areas D and E). |
Commercially available devices/tools |
8 | Grind mating surfaces on side roof paneling (1) in the cross-hatched area and around the holes (areas D and E) down to bare metal. |
Commercially available devices/tools |
9 | Remove shavings. |
Commercially available devices/tools |