ar6430s572501ea
Partially separate outer corner pillar paneling
Typ ar · temat 64.30 · wersja 0100 · 2014-12-15
Dotyczy: MODEL 447 without CODE W65 (Tailgate) without CODE W68 (Electrically-operated tailgate)
Niedostępne w języku „pl”; wyświetlono w języku Angielski.
Umiejscowienie
Grupa funkcyjna 3 Nadwozie › 64 Ściana tylna i tył pojazdu › 64.30 Poszycie naroża — Seria 447
EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.31 Ściana tylna/ tył pojazdu › 35.31.30 Ściana tylna/ tył pojazdu — Seria 447
EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.45 Słupek — Seria 447
AR64.30-S-5725-01EA
| Partially separate outer corner pillar paneling
|
|
|
MODEL
| 447
|
|
| without CODE W65 (Tailgate)
|
|
| without CODE W68 (Electrically-operated tailgate)
|
a
| Dimension 40 mm
|
| b
| Dimension 20 mm
|
1
| Scribe separating points and cut (areas A and B).
|
|
| Do not make the cuts too deep.
Otherwise the components below can be damaged and weakened.
|
2
| Expose spot welds on corner pillar (1), side corner pillar (2) and connecting panel (3) and cut out (areas C and D).
|
3
| Heat corner pillar (1) in crosshatched area.
|
|
| Cross-hatched area is bonded.
|
4
| Remove damaged corner pillar (1), side corner pillar (2) and connecting panel (3).
|
5
| Grind mating surfaces down to bare metal in the cross-hatched inner C-pillar sidewall .
|
|
| Sand down spot weld flanges to bare metal on both sides.
|
6
| Remove shavings and drill chips.
|
7
| Coat insides of spot weld flanges with zinc dust paint.
|
|
| Do not coat bonding surface (area E) with zinc dust paint.
Otherwise there may be adhesion problems.
|
|
| Observe pretreatment of bonding surface (area E).
|
