S64.30-4756-09
1 | Scribe separating point corner pillar (1) and cut (area A). |
Transfer separation point from vehicle. |
2 | Drill holes for section of corner pillar (2) for MAG welding (area B). |
3 | Grind mating surfaces on section of corner pillar (2) down to bare metal in crosshatched areas and around holes (area B). |
Sand down spot weld flanges to bare metal on both sides. |
4 | Remove shavings and drill chips. |
5 | Coat insides of spot weld flanges with zinc dust paint. |
S64.30-4757-09
6 | Scribe separating point on side corner pillar (3) and cut (area C). |
Transfer separation point from vehicle. |
7 | Drill holes on section of side corner pillar (4) for MAG welding (areas D and E). |
8 | Grind mating surfaces on section of side corner pillar (4) down to bare metal in crosshatched areas and around holes (areas D and E). |
Sand down spot weld flanges to bare metal on both sides. |
9 | Remove shavings and drill chips. |
10 | Coat insides of spot weld flanges with zinc dust paint. |
11 | Grind mating surfaces on reinforcement (5) and connecting panel (6) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
12 | Remove shavings and drill chips. |
13 | Coat insides of spot weld flanges with zinc dust paint. |
S64.30-4758-06
14 | Grind mating surfaces on inner corner pillar (7) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
15 | Remove shavings and drill chips. |
16 | Coat insides of spot weld flanges with zinc dust paint. |
S64.30-4800-06