129 589 03 23 00
Portal frame
Portal frame set
170 589 02 23 00
Commercially available tools
Number | Designation | |
WH58.30-Z-1001-02A | Hole punching pliers, dia. 6 mm. | |
WH58.30-Z-1003-02A | Clamping pliers | |
WH58.30-Z-1031-02A | C-clamp | |
WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm | |
WH58.30-Z-1024-04A | Abrasive disk, dia. 115 mm, 80 m/s (max. 13,250 rpm) | |
WH58.30-Z-1001-40A | Tarp (fire-resistant) |
Workshop equipment
WE58.40-Z-1001-02A | Inert gas welder |
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1002-03A | Straight grinder (electric/pneumatic) |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1005-03A | Wet/dry vacuum cleaner |
P64.10-0221-09
1 Cut inner right B-pillar off of new part (when replacing on right side of vehicle, cut off left inner B-pillar).
2 Grind rear wall down to bare metal in shaded areas. Then punch 6 mm dia. holes in rear wall (areas A-C).
-----------------------------------------------------------------------------------------
3 Install rear wall and screw to portal straightening set (main mount) on left and right. Fasten remaining connection surfaces with clamps and sheet metal screws.
-----------------------------------------------------------------------------------------
P64.10-0227-09
4 Weld rear wall in areas A-E and .
-----------------------------------------------------------------------------------------
-----------------------------------------------------------------------------------------