The following steps are shown on the left side of the vehicle and must be performed analogously on the right side in the event of damage.
1 | Mark separating points on rear fender (1) and cut (areas A and B). |
Transfer separation points from vehicle. |
P63.50-4182-06
P63.50-4183-09
2 | Cut out spot welds on lock striker bracket (2) (area C). |
Only if C-pillar is not replaced. |
3 | Drill out spot welds on lock striker bracket (2) with Ø 7 mm (area D). |
Only if C-pillar is not replaced. |
4 | Remove lock striker bracket (2). |
Only if C-pillar is not replaced. |
5 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
6 | Remove grinding dust and drill chips. |
7 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (area E). |
Observe pretreatment of bonding surfaces. |
8 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
9 | Remove grinding dust. |
10 | Coat insides of spot weld flanges with zinc dust paint. |
P63.50-4184-12