The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.
P63.50-3801-09
1 | Mark separating points on rear fender (1) and cut (areas A and B). |
Take separation points from vehicle. |
P63.50-3802-09
2 | Grind mating surfaces on rear fender (1) down to bare metal in the crosshatched area. |
Sand down spot weld flanges to bare metal on both sides. |
3 | Remove shavings and drill chips. |
4 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (areas C, D, E, F, G and H). |
Observe pretreatment of bonding surfaces. |