P63.50-3680-07
Shown on model 212.2 |
1 | Position metal needle templates or flexible measuring tape at Y-markings (arrows) and scribe separation line at rear fender (1) and cut (areas A and B). |
2 | Remove section from rear fender (1). |
P63.50-3863-09
Shown on model 212.2 |
3 | Grind mating surfaces on rear fender (1) down to bare metal in the crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
4 | Coat insides of spot welding flange on rear fender (1) with zinc dust paint suitable for spot welding. |
5 | Cut out spot welds on lock striker bracket (2) (area C). |
Only if C-pillar is not replaced. |
6 | Drill through spot welds on lock striker bracket (2) (area D). |
Only if C-pillar is not replaced. |
7 | Remove locking eye bracket (2). |
Only if C-pillar is not replaced. |