Blind rivet 6.512.5 (clamping range 2 mm to 5 mm, draw-off strength min. 19 kN)
A 004 990 16 97
BR00.45-Z-1056-07A
1K-zinc dust paint
A 000 986 28 00
The following operation steps are shown on the left side of the vehicle. In case of damage on the right side of the vehicle, these steps must be performed analogously. Additional information can be found in the superordinate service document. The safety information in the superordinate service document must be observed.
P63.40-3381-09
1
Install reinforcement (6) and fit.
2
Drill rivet holes on reinforcement (6) with a diameter of 6.7 mm (areas A1b, A2b, A3b, and A4b).
3
Remove reinforcement (6).
4
Deburr drill holes on both sides and remove drill chips from reinforcement (6) and body.
5
Coat drill holes on the reinforcement (6) and body on both sides with zinc dust paint (areas A1b, A2b, A3b and A4b).
P63.40-3382-09
6
Install reinforcement (6).
7
Rivet reinforcement (6) with rivets with a diameter of 6.5 x 12.5 mm (areas A1c, A2c, A3c, and A4c).
