ar6330d084603ts

Install center side longitudinal member

Typ ar · temat 63.30 · wersja 0100 · 2018-01-18

Dotyczy: Model 907.6/7

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 63 Ściana boczna › 63.30 Podłużnica na zewnątrz — Seria 907 (modele 6**, 7**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.41 Belka/ nadkole — Seria 907 (modele 6**, 7**)

AR63.30-D-0846-03TS

Install center side longitudinal member

Danger

The high voltage used for electric welding presents a lethal hazard. Risk of explosion from welding in areas close to highly inflammable materials. Risk of injury from weld splatter and UV-light when welding. Risk of poisoning from inhaling welding gases

Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove highly inflammable materials from the hazard area. Use air extraction system.

AS00.00-Z-0007-01A

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Measures for preventing damage to vehicles or components when performing electric welding work

AH00.00-N-0005-01A

000 588 01 84 00 Welder

WS60.00-P-0021K

000 588 02 84 00 Welder

WS60.00-P-0022K

Model

907.6/7

The following operation steps are shown on model 907.633 with code D03 (Roof and rear-end doors, high version) on the left side of vehicle and must be performed analogously on the right side of vehicle if damaged.

Install center side longitudinal member

D63.30-0334-07

1

Install center side longitudinal member (1), fit, and fix in place.

2

Center side longitudinal member (1) (areas Q and R).

3

Center side longitudinal member (1) (areas P, S, U, and V).

4

Center side longitudinal member (1)   (area T).

Install center side longitudinal member

5

Center side longitudinal member (1) (areas W and X).


D63.30-0335-12

Install center side longitudinal member

D63.30-0336-07

6

Center side longitudinal member (1) (area Y).

7

Face-grind inert gas plug welds on center side longitudinal member (1) (area Y).

8

Clean weld joints.

9

Remove shavings.

Powiązane dokumenty