Welding in door frame paneling bottom section

AR63.30-D-0002-04FA

Welding in door frame paneling bottom section

MODEL

909

1

Install, align and fix lower section of door frame paneling (1) in place.

2

Weld door frame paneling bottom section (1) to wheel arch, entrance and B-pillar   (arrows).

3

Weld door frame paneling bottom section (1) at rear to door frame paneling (9) and side wall paneling (3)   (6).

 Complete inert gas welds at intervals holding a steel or copper block from outside, allow to cool down in between.
Otherwise heat distortion can occur.

 Make vertical inert gas weld with a length of approx. 5 mm each at intervals of approx. 30 mm.

4

Weld door frame paneling bottom section (1) at front to door frame paneling (9)   (7).

 Complete inert gas welds at intervals holding a steel or copper block from outside, allow to cool down in between.
Otherwise heat distortion can occur.

5

Weld door frame paneling bottom section (1) to wheel arch   (arrows).

6

Weld door frame paneling bottom section (1) at bottom   (arrows).

7

Level inert gas welds.

8

Restore surface and smooth.

9

Remove grinding dust.