ar6330d000203ts

Preparing door frame paneling bottom section for installation

Typ ar · temat 63.30 · wersja 0100 · 2018-01-22

Dotyczy: Model 907.6/7, 910.6 except code T16 (Sliding door right) except code T19 (Sliding door left)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 63 Ściana boczna › 63.30 Podłużnica na zewnątrz — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.20 Kabina kierowcy/ karoseria › 35.20.50 Wejście — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

AR63.30-D-0002-03TS

Preparing door frame paneling bottom section for installation

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Model

907.6/7, 910.6

except code T16 (Sliding door right)

except code T19 (Sliding door left)

Repair materials

Number

Designation

Order number

BR00.45-Z-1056-07A

1K-zinc dust paint

A 000 986 28 00

The next steps are shown on the left component part and must be performed in a similar way in the event of damage on the right side of the vehicle.

Preparing door frame paneling bottom section for installation

D63.30-0317-09

a

Dimension (approx. 8 mm)

c

Dimension (approx. 280 mm)

b

Dimension (approx. 10 mm)

1

Scribe separation lines on door frame paneling lower section (1) (areas A, B and C).

Observe dimensions (A, B, C).

2

Cut door frame paneling lower section (1) at separating points (areas A, B and C).

3

Remove door frame paneling bottom section (1).

4

Grind down mating surfaces to bare metal in cross-hatched areas.

Sand down spot weld flanges to bare metal on both sides.

5

Zinc dust paint to insides of spot weld flanges.

Powiązane dokumenty