ar6320s111101e

Partially separate inner upper A-pillar reinforcement

Typ ar · temat 63.20 · wersja 0101 · 2016-05-24

Dotyczy: Model 447, 448

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 63 Ściana boczna › 63.20 Słupki — Seria 447 · Seria 448

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.45 Słupek — Seria 447 · Seria 448

AR63.20-S-1111-01E

Partially separate inner upper A-pillar reinforcement

Model

447, 448

Partially separate inner upper A-pillar reinforcement

S63.20-4680-09

a

Dimension approx. 200 mm

1

Mark separating point and cut (area A).

Do not cut too deeply.
Otherwise the components below can be damaged and weakened.

2

Expose spot welds on partial inner upper A-pillar reinforcement (1) and cut (areas B and C).

Partially separate inner upper A-pillar reinforcement

3

Heat partial inner upper A-pillar reinforcement (1) in crosshatched areas.


Crosshatched areas are bonded with adhesive.



4

Remove damaged partial inner upper A-pillar reinforcement (1).


S63.20-4681-06

Partially separate inner upper A-pillar reinforcement

S63.20-4682-09

5

Drill holes for MAG welding (area D).

6

Grind mating surfaces down to bare metal in crosshatched areas and around the holes (area D).

Sand down spot weld flanges to bare metal on both sides.

7

Remove shavings and drill chips.

8

Coat insides of spot weld flanges with zinc dust paint.

Do not coat bonding surfaces with zinc dust paint (areas E and F).
Otherwise there may be adhesion problems.

Observe pretreatment of bonding surfaces (areas E and F).