Niedostępne w języku „pl”; wyświetlono w języku Angielski.
Umiejscowienie
Grupa funkcyjna 3 Nadwozie › 63 Ściana boczna › 63.20 Słupki — Seria 447 · Seria 448
EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.45 Słupek — Seria 447 · Seria 448
AR63.20-S-1102-01E
Separate A-pillar outer section
Model
447, 448
Modification notes
18.05.2016
Method adapted
Operation steps 1 and 4
1
Mark separating points and cut (areas A and B).
Do not make the cuts too deep. Otherwise the components below can be damaged and weakened.
Model 447.8 with code PS2 (AMG line) Model 448.8 with code CN1 (Exterior rocker panel) Determine separating point in area A so that there is sufficient distance to the attachment points of the mounting rail on the longitudinal member panel.
Scribe separating point on A-pillar outer section (1) depending on degree of damage (area A).
a
Dimension approx.100 mm
S63.20-4756-06
2
Expose spot welds on A-pillar outer section (1) and cut out (area D).
S63.20-4757-09
3
Scribe separating points and cut around door hinge straps (areas D and E).
Do not make the cuts too deep. Otherwise the components below can be damaged and weakened.
4
Expose spot welds on A-pillar outer section (1) and cut out (areas F, F1 and G).
Model 447 with code JX0 (Short-distance operation) Cut out weld spots through 2 sheet metal thicknesses (area F1).
S63.20-4758-09
5
Expose spot welds on A-pillar outer section (1) and cut out (areas H to M).
6
Heat A-pillar outer section (1) in crosshatched area.
