Dotyczy: Model 907.6/7, 910.6 with code T16 (Sliding door right) Right side of vehicle Model 907.6/7, 910.6 with code T19 (Sliding door left) Left side of vehicle
Niedostępne w języku „pl”; wyświetlono w języku Angielski.
Additional information can be found in the superordinate service document.
The safety information in the superordinate service document must be observed.
The next steps are shown on model 907.6 with code T16 (right sliding door) on the right component part and must be carried out in the same way for vehicles with code T19 (left sliding door) on the left side of the vehicle in the event of damage.
1
Grind mating surfaces in the cross-hatched area (area A) down to bare metal from the rear.
Commercially available devices/tools Rotary wire brush
2
Grind down mating surfaces to bare metal in cross-hatched areas.
Sand down spot weld flanges to bare metal on both sides.
Commercially available devices/tools Rotary wire brush
3
Remove shavings.
Commercially available devices/tools Wet and dry vacuum cleaner
