D63.20-1103-09
1 | Mark separation line (8) with a length of d = 365 mm, at a distance of e = 225 mm (arrow) measured from edge to A-pillar inner section (1). |
2 | Mark separation line (9) on extension of separation line (8). |
3 | Mark contours (arrows) on A-pillar inner section (1). |
4 | Mark separation line (10) on body at a distance of f = 15 mm from marked sheet metal contours (arrows). |
5 | Separate A-pillar inner section (1) along separating lines (8, 9 und 10). |
6 | Punch Ø 6 mm holes in area (I) at a uniform distance of 40 mm. |
7 | Insert section between detached A-pillar inner and outer section and fit. |
8 | Transfer holes in area (J) to section and punch with Ø 6 mm bit. |
9 | Punch Ø 6 mm holes in area (K) at uniform distance of 30 mm starting at h = 190 mm, at distance of g = 25 mm from sheet metal edge. |
10 | Punch one Ø 6 mm hole each on upright/prone surface in area (L) at a distance of 8 mm from sheet metal edge. |
11 | Punch two Ø 6 mm holes at lower tip at a distance of 50 mm. |
Dimensions: |
12 | Grind off section in area of holes and coat with . |
D63.20-1104-06