D63.20-1113-09
1 | Mark separation line (10) with a length of d = 365 mm, at a distance of e = 225 mm measured from edge to A-pillar inner section (1). |
2 | Mark separation line (11) on extension of separation line (10). |
3 | Mark contours (arrows) on A-pillar inner section (1). |
4 | Mark separation line (12) at a distance of f = 15 mm from marked sheet metal contours (arrows) to body. |
5 | Separate A-pillar inner section (1) along separation lines (10, 11, 12). |
6 | Punch Ø 6 mm holes in area (I) at a uniform distance of 40 mm. |
7 | Insert section (2) between detached A-pillar inner section and A-pillar outer section and fit. |
8 | Transfer holes in area (J) to section (2) and punch with Ø 6 mm bit. |
9 | Punch Ø 6 mm holes in area (K) at uniform distance of 30 mm starting at h = 190 mm, at distance of g = 25 mm from sheet metal edge. |
10 | Punch one Ø 6 mm hole each on upright/prone surface in area (L) at a distance of 8 mm from sheet metal edge. |
11 | Punch two Ø 6 mm holes at lower tip at a distance of 50 mm. |
Dimensions: |
12 | Grind off section (2) in area of holes and coat with . |
D63.20-1114-06