Model | 447.601 |
with code T19 (Sliding door left) | |
with code W29 (Window fixed behind) | |
Left side of vehicle | |
Model | 447.601 |
with code W29 (Window fixed behind) | |
Right side of vehicle | |
Model | 447.701 |
with code T19 (Sliding door left) | |
with code W29 (Window fixed behind) | |
with code ZK4 (Mixto) | |
Left side of vehicle | |
Model | 447.701 |
with code W29 (Window fixed behind) | |
with code ZK4 (Mixto) | |
Right side of vehicle | |
Model | 447.811 |
Right side of vehicle | |
Model | 447.811 |
with code T19 (Sliding door left) | |
Left side of vehicle |
The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.
S63.10-5706-09
a | Dimension approx. 100 mm |
1 | Mark connecting points on sidewall paneling (1) and cut (areas A and B). |
Do not make the cuts too deep. |
2 | Expose spot welds on side wall paneling (1) and cut out (areas C to I). |
Cut out spot welds (arrows) through two panel thicknesses. |
3 | Expose spot weld and drill through (area J). |
S63.10-5668-06
4 | Heat sidewall paneling (1) in crosshatched areas. |
Cross-hatched areas are bonded with adhesive. |
5 | Remove damaged side wall paneling (1). |
S63.10-5721-06
S63.10-5708-09
6 | Grind mating surfaces down to bare metal in cross-hatched areas and around holes (areas K and L). |
Sand down spot weld flanges to bare metal on both sides. |
7 | Remove shavings and drill chips. |
8 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surface (area M) with zinc dust paint. |
Observe pretreatment of bonding surface (area M). |