Model | 447.601 |
with code T19 (Sliding door left) | |
with code W29 (Window fixed behind) | |
Left side of vehicle | |
Model | 447.601 |
with code W29 (Window fixed behind) | |
Right side of vehicle | |
Model | 447.701 |
with code T19 (Sliding door left) | |
with code W29 (Window fixed behind) | |
with code ZK4 (Mixto) | |
Left side of vehicle | |
Model | 447.701 |
with code W29 (Window fixed behind) | |
with code ZK4 (Mixto) | |
Right side of vehicle | |
Model | 447.811 |
Right side of vehicle | |
Model | 447.811 |
with code T19 (Sliding door left) | |
Left side of vehicle |
The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.
S63.10-5666-09
a | Dimension approx. 30 mm | b | Dimension approx. 7 mm |
1 | Mark connecting points on sidewall paneling (1) and cut (areas A and B). |
Do not make the cuts too deep. |
2 | Expose spot weld and cut out (area C). |
S63.10-5667-09
3 | Expose spot welds on side wall paneling (1) and cut out (areas D to I). |
Cut out spot welds (arrows) through two panel thicknesses. |
4 | Expose spot weld and drill through (area J). |
S63.10-5668-06
S63.10-5669-09
5 | Heat sidewall paneling (1) in crosshatched areas. |
Cross-hatched areas are bonded with adhesive. |
6 | Remove damaged side wall paneling (1). |
7 | Grind mating surfaces down to bare metal in crosshatched areas and around the holes (area K). |
Sand down spot weld flanges to bare metal on both sides. |
8 | Remove shavings and drill chips. |
9 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (areas L and M). |
Observe pretreatment of bonding surfaces (areas L and M). |
10 | Grind mating surfaces around hole (area N) down to bare metal. |
11 | Remove shavings and drill chips. |
S63.10-5670-03