The following steps are shown on the left side of the vehicle and must be performed analogously on the right side in the event of damage.
S63.10-5644-09
1 | Mark separating point on outer rear wheel well (1) and cut (area A). |
Transfer separation point from vehicle. |
2 | Grind mating surfaces on outer rear wheel well (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
3 | Remove shavings. |
4 | Coat insides of spot weld flanges with zinc dust paint. |
S63.10-5645-06