The following steps are shown on the left side of the vehicle and must be performed analogously on the right side in the event of damage.
S63.10-5641-09
a | Dimension approx. 20 mm |
1 | Mark separating point on outer rear wheel well (1) and cut (area A). |
2 | Remove damaged outer rear wheel well (1). |
3 | Mark separating points and cut (areas B and C). |
Do not make the cuts too deep. |
4 | Expose spot welds on outer rear wheel well (1) and cut out (areas D to F). |
5 | Remove sections from outer rear wheel well (1). |
S63.10-5642-06
6 | Sand down mating surfaces to bare metal in crosshatched areas . |
Sand down spot weld flanges to bare metal on both sides. |
7 | Remove shavings and drill chips. |
8 | Coat insides of spot weld flanges with zinc dust paint. |
S63.10-5643-06