Model | 447.603 |
with code T19 (Sliding door left) | |
with code W29 (Window fixed behind) | |
Left side of vehicle | |
Model | 447.603 |
with code W29 (Window fixed behind) | |
Right side of vehicle | |
Model | 447.703 |
with code T19 (Sliding door left) | |
with code W29 (Window fixed behind) | |
with code ZK4 (Mixto) | |
Left side of vehicle | |
Model | 447.703 |
with code W29 (Window fixed behind) | |
with code ZK4 (Mixto) | |
Right side of vehicle | |
Model | 447.813 |
Right side of vehicle | |
Model | 447.813 |
with code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 448.813 |
Right side of vehicle | |
Model | 448.813 |
with code T19 (Sliding door left) | |
Left side of vehicle |
The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.
S63.10-5577-09
x | Dimension approx. 15 mm |
1 | Mark separating point on side wall paneling (1) and cut (area A). |
Do not cut too deeply. |
2 | Expose spot welds on side wall paneling (1) and cut out (areas B to G). |
Cut out spot welds (arrows) through two panel thicknesses. |
S63.10-5578-09
3 | Expose spot welds on side wall paneling (1) and cut out (areas I and J). |
4 | Expose spot weld and drill out (area K). |
S63.10-5579-09
5 | Expose spot welds on rear side wall paneling bottom section (4) and cut out (areas L to O). |
6 | Expose MAG spot welds on rear side wall paneling bottom section (4) and cut out (area Q). |
7 | Cut inert gas welds on rear side wall paneling bottom section (4 (area P). |
8 | Heat sidewall paneling (1) in crosshatched areas. |
Crosshatched areas are bonded with adhesive. |
9 | Remove damaged side wall paneling (1). |
S63.10-5580-09
10 | Grind mating surfaces down to bare metal in crosshatched areas and around hole (area T). |
Sand down spot weld flanges to bare metal on both sides. |
11 | Remove shavings and drill chips. |
12 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (areas R and S). |
Observe pretreatment of bonding surfaces (areas R and S). |
S63.10-5581-09
13 | Grind mating surfaces down to bare metal in crosshatched areas and around hole (area U). |
Sand down spot weld flanges to bare metal on both sides. |
14 | Remove shavings and drill chips. |
15 | Coat insides of spot weld flanges with zinc dust paint. |