Prepare connection points of left side wall paneling with window cutout for installation

AR63.10-S-0120-03C

Prepare connection points of left side wall paneling with window cutout for installation

MODEL

415.603/7

without CODE T19 (Sliding door left)

1

Mark separating point on side wall paneling (1) and cut (area A).

 Transfer separation point from vehicle.

2

Punch holes for MAG welding on main floor (1) (areas B, C).

3

Grind side wall paneling (1) down to bare metal around holes (areas B, C).

4

Grind mating surfaces down to bare metal on sidewall paneling (1) in crosshatched areas.

 Sand down spot weld flanges to bare metal on both sides.

5

Remove shavings and drill chips.

6

Coat insides of spot weld flanges with zinc dust paint.

 Do not coat bonding surface (area D) with zinc dust paint.
Otherwise there may be adhesion problems.

 Observe preliminary treatment of bonding surface.

7

Grind mating surfaces down to bare metal on sidewall paneling (1) in crosshatched areas.

 Sand down spot weld flanges to bare metal on both sides.

8

Remove shavings and drill chips.

9

Coat insides of spot weld flanges with zinc dust paint.