The following operation steps are shown on the left side of the vehicle. In case of damage on the right side of the vehicle, these steps must be performed analogously.
Additional information can be found in the superordinate service document.
The safety information in the superordinate service document must be observed.
P63.10-5727-09
1 | Grind mating surfaces on the rear outer wheel well (1) down to bare metal in the cross-hatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
2 | Remove grinding dust. |
3 | Apply zinc dust paint to the insides of the spot weld flanges of the rear outer wheel well (1). |
Observe pretreatment of bonding surfaces. |
4 | Grind mating surfaces on the connecting panel (2) down to bare metal in the cross-hatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
5 | Remove grinding dust. |
6 | Apply zinc dust paint to the insides of the spot weld flanges of the connecting panel (2). |
Observe pretreatment of bonding surfaces. |
P63.10-5728-03