Separating right side wall paneling bottom section

AR63.10-D-5913-01FB

Separating right side wall paneling bottom section

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

General information on body repair

AH60.00-N-0001-01A

Model

909.843

except code T16 (Sliding door right)

except code W03 (Body extension)

1

Expose spot welds on side wall paneling (1) and cut out with  spot weld milling cutter (areas A and B).

2

Mark separating points on side wall paneling (1) approx. 1 mm in front of beaded edge and cut (areas E).

 Do not make the cuts too deep.
Otherwise the components below can be damaged and weakened.

3

Mark separating points on side wall paneling (1) and cut (areas F).

 Do not cut too deeply.
Otherwise the components below can be damaged and weakened.

 Dimensions:
f = 35 mm

4

Remove side wall paneling (1) lower section.