Separating right side wall paneling bottom section

AR63.10-D-5913-01FA

Separating right side wall paneling bottom section

 Warning

Risk of injury. Skin or eye injuries may result when handling hot or glowing objects.

Wear protective gloves, protective clothing and safety glasses, if necessary.

AS00.00-Z-0002-01A

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

General information on body repair

AH60.00-N-0001-01A

Model

909.6

with code T16 (Sliding door right)

Model

909.843

with code T16 (Sliding door right)

except code W03 (Body extension)

1

Expose spot welds on side wall paneling (1) and cut out with  spot weld milling cutter (areas A, B and C).

2

Mark separating points on side wall paneling (1) and cut (areas D).

 Do not cut too deeply.
Otherwise the components below can be damaged and weakened.

3

Mark separating point on side wall paneling (1) approx.. 1 mm in front of beaded edge and cut (area E).

 Do not cut too deeply.
Otherwise the components below can be damaged and weakened.

4

Mark separating points on side wall paneling (1) and cut (areas F).

 Do not cut too deeply.
Otherwise the components below can be damaged and weakened.

 Dimensions:
f=35 mm

5

Model 909.633
with code T16 (Sliding door right)
Model 909.843
with code T16 (Sliding door right)
except code W03 (Body extension)
Heat sidewall paneling (1) in area of wheel arch.

 The side wall paneling (1) is bonded in the area of the wheel arch.

6

Remove side wall paneling (1) lower section.