Commercially available tools
Workshop equipment
WE58.40-Z-1001-02A | Inert gas welder |
WE58.40-Z-1002-02A | Spot welder |
WE58.40-Z-1003-02A | Multifunction device |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1004-03A | Body saw (electric/pneumatic) |
D63.10-0060-06
1 Weld right side wall paneling bottom section (1) to side wall paneling upper section (19) and outer corner pillar paneling (5) ( , arrows).
D63.10-0061-06
2 Weld right side wall paneling (1) to C-pillar (12) ( , arrows).
3 Weld right side wall paneling (1) to load compartment sliding door entry (4) ( , 13).
D63.10-1148-12
To prevent the sheet metal parts from distorting, hold steel or copper block to side wall paneling from outside. The block (approx. 25 mm x 25 mm x 200 mm) should make full contact.
4 Weld right side wall paneling to side wall inner section (10) or , arrows).
D63.10-1175-01
5 Weld right side wall paneling (1) on inner side wall section and wheelhouse
( , arrows).
D63.10-1176-01
6 Weld right side wall paneling (1) on rear inner side wall section and wheelhouse ( , arrows).
D63.10-1178-02
7 Weld right side wall paneling (1) on front and rear end section ( ).
D63.10-1179-02
D63.10-1149-12
8 Cut out window cutout of side wall along inner section of side wall (dotted line).
9 Deburr cutting edge.