Separate right side wall paneling up to window cutout

AR63.10-D-5892-01FA

Separate right side wall paneling up to window cutout

 Warning

Risk of injury. Skin or eye injuries may result when handling hot or glowing objects.

Wear protective gloves, protective clothing and safety glasses, if necessary.

AS00.00-Z-0002-01A

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

General information on body repair

AH60.00-N-0001-01A

Model

909.843

with code T16 (Sliding door right)

except code W03 (Body extension)

1

Expose spot welds on side wall paneling (1) and cut out with  spot weld milling cutter (areas A, B and C).

2

Mark connecting points on sidewall paneling (1) and cut (areas B and E).

 Do not make the cuts too deep.
Otherwise the components below can be damaged and weakened.

 Dimensions:
d = approx. 100 mm
e = approx. 100 mm

3

Mark separating point on side wall paneling (1) approx. 1 mm in front of beaded edge and cut (area F).

 Do not cut too deeply.
Otherwise the components below can be damaged and weakened.

4

Expose spot welds on side wall paneling (1) and cut out with  spot weld milling cutter (area G).

5

Mark separating point on side wall paneling (1) and cut (area H).

 Do not cut too deeply.
Otherwise the components below can be damaged and weakened.

6

Heat side wall paneling (1) in area of side wall reinforcements (3).

 The side wall paneling (1) is bonded in the area of the side wall reinforcements (3).

7

Remove side wall paneling (1).