Model | 907.6/7 |
with code D03 (Roof and rear-end doors, high version) | |
with code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.6/7 |
with code D03 (Roof and rear-end doors, high version) | |
with code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 907.6 |
with code D05 (Super-high roof) | |
with code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.6 |
with code D05 (Super-high roof) | |
with code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 907.6 |
with code D06 (Super-high roof painted in vehicle colour) | |
with code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 907.6 |
with code D06 (Super-high roof painted in vehicle colour) | |
with code T19 (Sliding door left) | |
Left side of vehicle | |
Model | 910.6 |
with code D03 (Roof and rear-end doors, high version) | |
with code T16 (Sliding door right) | |
Right side of vehicle | |
Model | 910.6 |
with code D03 (Roof and rear-end doors, high version) | |
with code T19 (Sliding door left) | |
Left side of vehicle |
Additional information can be found in the superordinate service document.
The safety information in the superordinate KD document must be observed.
The next steps are shown on model 907.6 with code T16 (right sliding door) on the right component part and must be carried out in the same way for vehicles with code T19 (left sliding door) in the event of damage to the left side of the vehicle.
D63.10-2081-09
b | Dimension (approx. 8 mm) |
1 | Mark separating point on rear side wall paneling (1) (area B). |
Observe dimension (b). |
2 | Disconnect separating point from rear side wall paneling (1) (area B). |
Commercially available devices/tools |
3 | Dispose of the leftover piece that has been separated off. |
D63.10-1920-09
4 | Punch holes in rear side wall paneling (1) with Ø 6 mm (area C). |
Commercially available devices/tools |
5 | Drill holes in rear side wall paneling (1) with Ø 7 mm (areas D and E). |
Commercially available devices/tools |
6 | Grind mating surfaces on rear side wall paneling (1) in cross-hatched areas and around holes (areas C, D, and E) down to bare metal. |
Grind holes (area C) on the rear side down to bare metal. |
Sand down spot weld flanges to bare metal on both sides. |
Commercially available devices/tools |
7 | Remove shavings and drill chips. |
Commercially available devices/tools |
8 | Zinc dust paint to insides of spot weld flanges. |
9 | Punch holes in rear side wall paneling (1) with Ø 6 mm (area G). |
Commercially available devices/tools |
10 | Grind mating surfaces on rear side wall paneling (1) down to bare metal in cross-hatched areas and around holes (area G). |
Sand down spot weld flanges to bare metal on both sides. |
Commercially available devices/tools |
11 | Remove shavings. |
Commercially available devices/tools |
12 | Zinc dust paint to insides of spot weld flanges. |
D63.10-2083-06