Prepare inner section of rear side wall paneling for installation
Model
907.6/7, 910.6
Repair materials
Number
Designation
Order number
BR00.45-Z-1056-07A
1K-zinc dust paint
A 000 986 28 00
Additional information can be found in the superordinate service document.
The safety information in the superordinate service document must be observed.
The next steps are shown on the left component parts on model 907.633 and must be performed in a similar manner on vehicles with damage on the right side of the vehicle.
1
Model 907.6 with one window in rear side wall, model 907.7 Mark separating points on inside part of sidewall (1) (areas A, A1, B, and B1).
Transfer separation lines from vehicle.
2
Model 907.6 with one window in rear side wall, model 907.7 Cut separating points on inside part of sidewall (1) (areas A, A1, B, and B1).
Commercially available devices/tools Body power jigsaw
3
Model 907.6 with one window in rear side wall, model 907.7 Dispose of remaining pieces (1.1, 1.2).
D63.10-A018-12
D63.10-A017-09
4
Punch holes with a diameter of 6 mm in reinforcement (2) (area E), reinforcement (3) (area F), and inside part of sidewall (1) (areas C and D).
Commercially available devices/tools Hole punching pliers 6 mm
5
Grind mating surfaces in cross-hatched areas and around holes in reinforcement (2) (area E), reinforcement (3) (area F) and inside part of sidewall (1) (areas C and D) down to bare metal.
Sand down spot weld flanges to bare metal on both sides.
Commercially available devices/tools Rotary wire brush
6
Remove shavings.
Commercially available devices/tools Wet and dry vacuum cleaner
