ar6310d002903f

Install rear sidewall paneling behind wheel arch up to window cutout

Typ ar · temat 63.10 · wersja 0100 · 2013-10-02

Dotyczy: MODEL 909.843 with CODE W03 (Body extension)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 63 Ściana boczna › 63.10 Ściana boczna — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.35 Błotnik/ ściana boczna — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.38 Poszycie z lewej strony — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.39 Poszycie z prawej strony — Seria 909 (modele 843)

AR63.10-D-0029-03F

Install rear sidewall paneling behind wheel arch up to window cutout

MODEL

909.843

with CODE W03 (Body extension)

Install rear sidewall paneling behind wheel arch up to window cutout

D63.10-1702-09

The following operation steps are shown on the left side of the vehicle on MODEL 909.843 and must be performed analogously on the right side in the event of damage.

1

Install rear side wall (1), fit and fix in place.

2

Tack weld rear side wall (1).

3

Rear side wall (1) (areas A and B).

4

Rear side wall (1) (areas D, E, F and H).

5

Rear side wall (1) (area C).

Insert gas weld in intervals, allow to cool down in between.
Otherwise heat distortion can occur.

6

Rear side wall (1) (area J).

Complete inert gas welds at intervals holding a steel or copper block from outside, allow to cool down in between.
Otherwise heat distortion can occur.

Make inert gas welds with a length of approx. 5 mm each at intervals of approx. 30 mm.

7

Level inert gas welds (areas C and J).

Inert gas welds are sealed later with sealant.

8

Grind rear side wall (1) down flat (areas C, D, E, F and H).

9

Restore surface and smooth (areas C, D, E, F and H).

10

Remove grinding dust.