ar6310d002801f

Remove rear sidewall paneling behind wheel arch up to bead

Typ ar · temat 63.10 · wersja 0100 · 2013-10-02

Dotyczy: MODEL 909.843 with CODE W03 (Body extension)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 63 Ściana boczna › 63.10 Ściana boczna — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.35 Błotnik/ ściana boczna — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.38 Poszycie z lewej strony — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.39 Poszycie z prawej strony — Seria 909 (modele 843)

AR63.10-D-0028-01F

Remove rear sidewall paneling behind wheel arch up to bead

MODEL

909.843

with CODE W03 (Body extension)

Remove rear sidewall paneling behind wheel arch up to bead

D63.10-1703-09

The following operation steps are shown on the left side of the vehicle on MODEL 909.843 and must be performed analogously on the right side in the event of damage.

1

Scribe cuts on rear side wall (1) and cut (areas F and G).

Do not make the cuts too deep.
Otherwise the components below can be damaged and weakened.

Dimensions:
g = 35 mm

2

Expose spot welds on rear side wall (1) and cut out (areas B, D and E).

Remove rear sidewall paneling behind wheel arch up to bead

3

Expose weld seams (arrows) on rear side wall (1) and cut.


4

Remove rear side wall (1).

D63.10-1704-06

Remove rear sidewall paneling behind wheel arch up to bead

5

Expose spot welds and cut out (area H).


6

Remove section.

D63.10-1705-11

Remove rear sidewall paneling behind wheel arch up to bead

7

Grind mating surfaces down to bare metal in the cross-hatched inner C-pillar side wall .


Sand down spot weld flanges to bare metal on both sides.


8

Remove grinding dust and drill chips.


9

Coat inside of spot welding flanges with zinc dust paint.

D63.10-1706-11