ar6310d002703f

Install rear sidewall paneling behind wheel arch

Typ ar · temat 63.10 · wersja 0100 · 2013-10-02

Dotyczy: MODEL 909.843 with CODE W03 (Body extension)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 63 Ściana boczna › 63.10 Ściana boczna — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.35 Błotnik/ ściana boczna — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.38 Poszycie z lewej strony — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.39 Poszycie z prawej strony — Seria 909 (modele 843)

AR63.10-D-0027-03F

Install rear sidewall paneling behind wheel arch

MODEL

909.843

with CODE W03 (Body extension)

Install rear sidewall paneling behind wheel arch

D63.10-1695-09

The following operation steps are shown on the left side of the vehicle on MODEL 909.843 and must be performed analogously on the right side in the event of damage.

1

Install rear side wall (1), fit and fix in place.

2

Tack weld rear side wall (1).

3

Rear side wall (1) (areas A and B).

4

Rear side wall (1) (areas C, D, E, F, G and H).

5

Rear side wall (1) (area J).

Complete inert gas welds at intervals holding a steel or copper block from outside, allow to cool down in between.
Otherwise heat distortion can occur.

Make inert gas welds with a length of approx. 5 mm each at intervals of approx. 30 mm.

6

Level inert gas welds (area J).

Inert gas welds are sealed later with sealant.

7

Grind rear side wall (1) down flat (areas C, D, E, F, G and H).

8

Restore surface and smooth (areas C, D, E, F and H).

9

Remove grinding dust.