Weld-in sidewall paneling at left up to window cutout

AR63.10-D-0002-04F

Weld-in sidewall paneling at left up to window cutout

Model

909.843

except code W03 (Body extension)

1

Install left side wall paneling (1), fit and fix in place.

 Glue left side wall paneling (1) to side wall reinforcements (3).

2

Weld left side wall paneling (1) to upper side wall paneling (19), front side wall paneling (14) and corner pillar paneling (5)   (arrows).

 Complete inert gas welds at intervals holding a steel or copper block from outside, allow to cool down in between.
Otherwise heat distortion can occur.

 Make inert gas welds on left side wall paneling (1) on front side wall paneling (14) and corner pillar paneling (5) with a length of approx. 5 mm each at intervals of approx. 30 mm .

3

Weld left side wall paneling to inner side wall (10)   (arrows).

4

Weld left side wall paneling to window cutout of inner side wall (10)   (arrows).

5

Weld left side wall paneling (1) to inner front side wall and wheel arch   (arrows).

6

Weld left side wall paneling (1) to rear inner side wall and wheel arch   (arrows).

7

Cut out window cutout on left side wall paneling along window cutout on inner side wall (10) (broken line).

8

Deburr cutting edge.

9

Grind left side wall paneling down flat.

10

Restore surface and smooth.

11

Remove grinding dust.