Additional information can be found in the superordinate service document.
The safety information in the superordinate service document must be observed.
The following operation steps are shown on model 907.633 with code D03 (Roof and rear-end doors, high version) on the left side of vehicle and must be performed analogously on the right side of vehicle if damaged.
D62.10-1244-09
1 | Install front longitudinal member up to passenger compartment floor area (1), fit, and fix in place. |
Commercially available devices/tools |
2 | Reshape crossmember (3) (arrows). |
3 | Front longitudinal member up to passenger compartment floor area (1) (areas A, B, and C). |
4 | Front longitudinal member up to passenger compartment floor area (1) (areas D, E, and F). |
D62.10-1245-06
5 | Front longitudinal member up to passenger compartment floor area (1) (areas G and H). |
D62.10-1246-06
6 | Drill holes in the vehicle floor (2) with Ø 7 mm (area I). |
Drill only through vehicle floor (2). |
Commercially available devices/tools |
7 | Remove drilling chips. |
Commercially available devices/tools |
D62.10-1247-03
8 | Front longitudinal member up to passenger compartment floor area (1) (areas J, K, L, M, N, O, P, and P1). |
9 | Surface-grind inert gas plug welds on front longitudinal member up to passenger compartment floor area (1) (areas J, K, L, M, N, O, P, and P1). |
Commercially available devices/tools |
D62.10-A001-06
10 | Front longitudinal member up to passenger compartment floor area (1) (area Q). |
11 | Clean weld joints. |
Commercially available devices/tools |
12 | Remove shavings. |
Commercially available devices/tools |